Part 6 - More Illumination

To reinforce the luminosity, at the bottom of the case were placed three high luminescence blue LEDs.  One pointing down and the other two in the legs.  They are isolated with termocontraible, they are covered silicone and are encapsulated in a translucent blue box (Tic-Tac Box), to achieve a better effect.

It was fixed to the case and the tips of LEDs to which were welded a male pin, which is the inner side of the cabinet which by two female connectors could easily connect and disconnect.  The wiring came from a referral of feeding the LEDs handles, and thus are switched on and off everything as a whole.

Part 7- Graphic Mounting
On the exterior side without the lock, remove all the components and clean the metal with isopropyl alcohol.  Get the poster sticker and cut it to shape with 1cm bleed (over), for bending.  Cut the poster so the the mounting brackets can go through.  Put the poster back on to make sure it will fit.

Once the metail is clean and poster is read, rest one of the edges of the poster on the case and remove the protection.  Slowly remove the rest of te protection and place the sticker on the metal.  If there are any air bubbles, use a pin or the ;

Once ready surface and the poster, rests one of the edges of the poster, after withdrawal of protection.  is slowly withdrawing the rest of protecting and supporting the poster on the surface.  When we're done, if there were any air bubbles will drop with the help of a pin or the tip of the cutter, double the edges inward.

Part 8 - Front Logo
On the front panel, make the number three in aluminum, and attach it to the reader in the top bay.

Part 9 - Top Spider
Next we cut a spider emblem out of aluminum and attach it to the top of the case.

Part 10 - Case Painting

The plastic coverings were painted in black colour and make a spider web design on them, first white then above this in silver color.  We used some special permanent markers, then made a splash on the surface with the silver.  (as seen in some previous pictures)

Part 11 - Optical Drive Coloring
The reader is painted red and underwent the dithering of the web following the exterior design.  The reason for this change of color is to show that the duality is shown in the film Spiderman 3.

Part 12 - More Lights
There is a cathode blue bulg to highlight the inside better.  The instensity controller is in a transparent brackelt.

Part 13 - USB Hub

There is a custom USB hub on the SpiderMac, giving it a USB port up front, next to the optical drive bay.  The full tutorial is available here.

Part 13 - Step 1 - Disassemble an external USB hub.
Remove the hub from the casing and remove the weld from some of the ports.

Part 13 - Step 2 - Create your own USB board
Weld and wire your own USB board, with connections from the original USB hub.

Part 13 - Step 3 - Attach pieces to bracket.
Once you have the two boards, join them together and then place them on a custom PCI bracket.

Part 13 - Step 4 - Rewire the feed and 4th USB port
You'll want USB access from the front, so make a custom USB wire to go from the hub to the front of the case (with a whole drilled to accept the female USB port).

Run the USB hub's wire from the back of the Mac to the new PCI bracket.